L2 Switching Configuration; L2 Switching Configuration Steps - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

Left running head:
Chapter name (automatic)
Layer 2 Switching Configuration
L2 S C
WITCHING
Refer to the following steps to enable switching on the L2 card in the OA-700.
L2 S C
WITCHING ONFIGURATION
The following commands enable switching on the L2 card in the OA-700.
Step 1: Enter Configuration Mode.
Step 2: Configure a L2 interface. See
Step 3: Administratively bring up the interface. See
Down the L2 Interface"
Step 4: L2 interface can be configured for four modes of operation. Following are
the steps to configure L2 to either Access, Trunk or Hybrid mode. These steps are
optional.
•
Configure L2 interface to operate in Pure Bridging Mode:
Step 1: Configure L2 interface to Pure Bridging mode by using "no
switchport mode" command. See
(If no access VLAN is configured)
OR
•
Configure L2 interface to operate in Access Mode:
Step 1: Configure L2 interface to Access mode by using "no switchport
mode" command. See
Hybrid mode is already configured)
Step 2: Configure VLAN for Access mode. See
Access Mode"
OR
•
Configure L2 interface to operate in Trunk Mode:
Step 1: Configure L2 interface to Trunk mode. See
the L2 Interface"
Step 2: Configure tagged VLANs that will be allowed when the interface is
configured to Trunk mode. See
OR
168
Beta
ONFIGURATION
S
TEPS
ALU# configure terminal
ALU(config)#
"To Configure Mode for the L2 Interface"
"To Configure Trunk VLAN"
Alcatel-Lucent
"To Configure an L2 Interface"
"To Administratively Bring Up/
"To Configure Mode for the L2 Interface"
"To Configure VLAN for
"To Configure Mode for
(if Trunk/
CLI Configuration Guide
Beta