Rip Configuration Commands - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

RIP C
ONFIGURATION
T E RIP
O NABLE
router rip
E
XAMPLE
ALU(config)# router rip
ALU(config-router rip)#
T C
O ONFIGURE A
RIP sends updates to the interfaces in the specified networks. If an interface's
network is not specified, it will not be advertised in any RIP update. There is no
limit to the number of network commands you can use on the router. RIP routing
updates will be sent and received only through interfaces which falls in the
configured network.
Command (in RCM)
network <network-number>
no network <network-number>
E
XAMPLE
ALU(config-router rip)# network 10.0.0.0
ALU(config-router rip)# no network 10.0.0.0
CLI Configuration Guide
Beta
C
OMMANDS
Command (in CM)
RIP N
ETWORK
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Description
This command enters into the Router
Configuration mode. This enables to
configure RIP specific commands.
Description
Associates a specific network with a RIP
routing process.
The 'no' command disables the
configured network.
RIP stops sending updates through
interfaces on this network. Also these
interfaces will not be advertised in any
RIP updates.
RIP Configuration
473
Beta