Vrrp Cli Commands - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

Left running head:
Chapter name (automatic)
Virtual Router Redundancy Protocol
VRRP CLI C
OMMANDS
This section details the commands that are used in configuring VRRP.
T C I
O ONFIGURE AN NTERFACE
VRRP is enabled on a per-interface basis. VRRP runs on multi-access networks
like Ethernet.
Command (in CM)
interface <name>
E
XAMPLE
ALU(config)# interface GigabitEthernet7/0
ALU(config-if GigabitEthernet7/0)#
T C VRRP G
O ONFIGURE
Note: Group ID is in the range 1 - 8.
Command (in ICM)
vrrp <1-8> ip <ip-address>
no vrrp <1-8> ip <ip-
address>
no vrrp <1-8>
E
XAMPLE
ALU(config-if GigabitEthernet7/0)#vrrp 5 ip 10.91.0.8
ALU(config-if GigabitEthernet7/0)#no vrrp 5 ip 10.91.0.8
136
Beta
P IP A
ROUP AND RIMARY
Alcatel-Lucent
Description
This command is used to configure an
interface.
G
DDRESS FOR THE ROUP
Description
This command configures a VRRP group with
the specified ID on the interface, and specifies
a primary IP address for the VRRP group.
This command removes the primary IP
address for the specified VRRP group on an
interface. VRRP group is disabled as a result.
This command removes all configuration
associated with the VRRP group on the
interface.
CLI Configuration Guide
Beta