To Attach Crypto Map To An Interface - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

T A IKE I
O TTACH AN DENTITY TO A
Command (in Crypto Map CM)
ike-identity <name>
no ike-identity
Note: IKE identity should only be attached to a crypto map if the Authentication type is 'rsa-
sig'.
E
XAMPLE
ALU(config-crypto-map-exampleMap)# ike-identity exampleIdentity
ALU(config-crypto-map-exampleMap)# no ike-identity
T A C
O TTACH RYPTO
Crypto map needs to be applied to an interface through which the IPsec traffic
flows. Binding a crypto map to an interface instructs the system to evaluate all the
interface traffic against the crypto map, and to use the specified policy during
connection or security association negotiation.
Command (in ICM)
crypto map <map-name>
no crypto map <map-name>
E
XAMPLE
ALU(config)# interface GigabitEthernet7/0
ALU(config-if GigabitEthernet7/0)# crypto map exampleMap
ALU(config-if GigabitEthernet7/0)# no crypto map exampleMap
CLI Configuration Guide
Beta
C M
RYPTO AP
M I
AP TO AN NTERFACE
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Description
This command attaches an IKE identity to
a crypto map.
The 'no' command detaches the specified
IKE identity attached to a crypto map.
Description
Enter this command in the Interface
Configuration Mode.
This command attach a crypto map to an
interface.
This command is used to detach the crypto
map attached to an interface.
Note: You cannot delete a crypto map
that is applied to an interface. To
delete, first detach the crypto
map from the interface.
IPsec VPN Configuration
773
Beta