Firewall Debug Commands - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

Left running head:
Chapter name (automatic)
Filter and Firewall
F D C
IREWALL EBUG OMMANDS
This section lists the debug commands in firewall.
T E /D D
O NABLE ISABLE EBUGGING
Command (in SUM)
debug firewall
{session|filter|nat|attack|alg
|intrusion|selector [saddr
<ip-address>|daddr <ip-
address>|protocol <number> |
sport <number>|dport
<number>][output|permanent]|
all [detail-level]}
no debug firewall
{session|filter|nat|attack|alg
|intrusion|selector [saddr
<ip-address>|daddr <ip-
address>|protocol <number> |
sport <number>|dport
<number>][output|permanent]|
all [detail-level]}
Notes: 1. saddr == source address
2. daddr == destination address
3. sport == source port
4. dport == destination port
E
XAMPLE
The example below enables debugging for the source IP 10.91.0.52
ALU# debug firewall selector saddr 10.91.0.52
The example below disables debugging for the source IP 10.91.0.52
ALU# no debug firewall selector saddr 10.91.0.52
694
Beta
O F
N IREWALL
Use this command to turn on debugging
for specified firewall features.
The "selector" keyword allows you to
debug only selected traffic.
Use this command to turn off the
debugging functionality.
The "selector" keyword allows you to
turn off debugging only for selected
traffic.
Alcatel-Lucent
Description
CLI Configuration Guide
Beta