Multilink Point To Point Protocol; Chapter Conventions - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

C 17
HAPTER
This chapter includes the commands for configuring Multilink Point-to-Point
Protocol (MLPPP) encapsulation on a T1 or an E1 interface or a Serial (V.35/X.21)
interface. You are required to refer to the
Port (USP) Line Card"
For instructions on using the MLPPP commands and descriptions on each of their
parameters, refer to the OmniAccess 700 CLI Command Reference Guide.
The chapter is divided into the following sections:
•
"MLPPP Overview"
•
"MLPPP Configuration"
•
"MLPPP Configuration Example"
C C
HAPTER ONVENTIONS
Acronym
CM
CPE
ICM
IPCP
FR
LCP
MLPPP
MRRU
MTU
PPP
SPE
SSHNF
SUM
CLI Configuration Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
M P
ULTILINK OINT TO
chapters before proceeding to this.
Configuration Mode - ALU (config)#
Customer Premises Equipment
Interface Configuration Mode - ALU (config-interface name)#
IP Control Protocol
Frame Relay
Link Control Protocol
Multi Link Point to Point Protocol
Maximum Receive Reconstructed Unit
Maximum Transmission Unit
Point-to-Point Protocol
Service Provider Equipment
Short Sequence Header Number Format
Super User Mode - ALU#
Alcatel-Lucent

Multilink Point to Point Protocol

P P
OINT
"T1E1 Line Card" and "Universal Serial
Description
Beta
ROTOCOL
347