Pvst+ Configuration Commands - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

PVST+ C
ONFIGURATION
This section details on the commands, which are used to configure Spanning Tree
Protocol.
T E PVST+
O NABLE
Note: Each "spanning tree" command will be based on some VLAN. If the VLAN-ID is not
entered, by default it is taken as VLAN-1.
Command (in CM)
spanning-tree [vlan <1-4094>] This command is entered in the
no spanning-tree [vlan <1-
4094>]
E
XAMPLE
The following command enables the spanning tree for the default VLAN-id, i.e.,
VLAN-1:
ALU(config)# spanning-tree
The deletion of the spanning tree will follow the same rule.
ALU(config)# no spanning-tree
The following example configures spanning tree for VLAN 100:
ALU(config)# spanning-tree vlan 100
The deletion of the spanning tree will follow the same rule.
ALU(config)# no spanning-tree vlan 100
CLI Configuration Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
C
OMMANDS
Alcatel-Lucent
Description
configuration mode. This command
enables a spanning-tree for VLAN.
The "no" command disables the
configured spanning-tree for a VLAN.
Beta
PVST+ Configuration
187