Ethernet Interface Configuration Commands - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

E I
THERNET NTERFACE
This section provides an expansive view on the commands that are used in
configuring the Ethernet Interfaces.
T C G E I
O ONFIGURE IG NTERFACE
interface GigabitEthernet
<slot/port>
E
XAMPLE
The following example shows configuring GigE interface:
ALU(config)# interface GigabitEthernet 7/0
ALU(config-if GigabitEthernet7/0)#
T C D O
O ONFIGURE UPLEX
duplex {auto|full|half}
no duplex
E
XAMPLE
ALU(config-if GigabitEthernet7/0)# duplex full
ALU(config-if GigabitEthernet7/0)# no duplex
T C F C
O ONFIGURE LOW ONTROL
flowcontrol {receive|send}
{off|on}
no flowcontrol {receive|send}
{off|on}
E
XAMPLE
ALU(config-if GigabitEthernet7/0)# flowcontrol send on
ALU(config-if GigabitEthernet7/0)# no flowcontrol send on
CLI Configuration Guide
Beta
C C
ONFIGURATION
Command (in CM)
PERATION
Command (in ICM)
Command (in ICM)
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
OMMANDS
Description
This command allows you to configure
GigE interface.
Description
This command configures duplex
operation on an interface.
The "no" command sets the duplex
mode to its default.
The default duplex mode is "auto".
Description
This command configures flow control
on a GigE interface.
The "no" command sets the flow control
to its default. By default, flow control is
set to "Off".
Ethernet Configuration
157
Beta