Frame Relay; Chapter Conventions - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

C 14
HAPTER
This chapter includes the commands for configuring Frame Relay (FR)
encapsulation on a T1 or E1 interface or a Serial (V.35/X.21) interface. You are
required to refer to the
Card" chapters before proceeding to this.
This chapter includes instructions for configuring Frame Relay Local Management
Interface and Data-link Connection Identifiers on an interface/sub-interface
through the CLI. For instructions on using the FR commands and descriptions on
each of their parameters with the corresponding default values for each, refer to
the OmniAccess 700 CLI Command Reference Guide.
This chapter is divided into the following sections:
•
"Frame Relay Overview"
•
"Frame Relay Configuration"
The overview section serves only as an additional information on the FR protocol.
You can skip this section and directly proceed to
section.
C C
HAPTER ONVENTIONS
Acronym
SUM
CM
ICM
S-ICM
DLCI
DCE
DTE
LMI
CLI Configuration Guide
Beta
F R
RAME ELAY
"T1E1 Line Card"
Super User Mode - ALU #
Configuration Mode - ALU (config)#
Interface Configuration Mode - ALU (config-interface name)#
Sub-Interface Configuration Mode - ALU (config-subif serial slot/
port:channel.subchannel)#
Data-link Connection Identifier
Data Circuit-Terminating Equipment
Data Terminal Equipment
Local Management Interface
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
and "Universal Serial Port (USP) Line
"Frame Relay Configuration"
Description

Frame Relay

295
Beta