To Configure Rules Using The Protocol Numbers - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

T C R
O ONFIGURE ULES FOR
Command (in Match-list CM)
[<1-65535>] icmp {any|host <source
ip-address>|interface <name>|list
<name>|prefix <source ip-address/
prefix length>} {any|host
<destination ip-address>|interface
<name>|list <name>|prefix
<destination ip-address/prefix
length>} [dscp {<0-63>|<dscp-
mnemonics}|fragment|icmp-type <0-
255> [icmp-subtype <0-255>]|ip-
precedence {<0-7>|<precedence-
mnemonics>}|length {<1-
1500>|{eq|ge|gt|le|lt|range <1-
1500>}}|tos {<0-15>|<tos-
mnemonics>}]
E
XAMPLE
The following example configures a ICMP rule with 'any any' and icmp-type value
10, and icmp-subtype value 5':
ALU(config-match-list-test)# icmp any any icmp-type 10 icmp-
subtype 5
T C R U
O ONFIGURE ULES
Command (in Match-list CM)
[<1-65535>] protocol <1-65535>
{any|host <source ip-address>
|interface <name> |list
<name>|prefix <source ip-address/
prefix length>} {any|host
<destination ip-address>|interface
<name>|list <name>|prefix
<destination ip-address/prefix
length>} [dscp {<0-63>|<dscp-
mnemonics}|fragment|ip-precedence
{<0-7>|<precedence-mnemonics>}
|length {<1-1500>
|{eq|ge|gt|le|lt|range <1-1500>}}
|tos {<0-15>|<tos-mnemonics>}|type
{ftp|normal|rpc|sip|tftp}]
E
XAMPLE
The following example configures a rule using the Protocol number '1' with 'any
any' and dscp value 10:
ALU(config-match-list-test)# 10 protocol 1 any any dscp 10
CLI Configuration Guide
Beta
ICMP
P N
SING THE ROTOCOL UMBERS
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Description
This command is used to
configure rules for the ICMP
protocol in a match-list.
Description
This command is used to
configure rules using the protocol
numbers.
CC Configuration
423
Beta