Source Nat Configuration - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

Release versions: 2.2, 2.2-r02, 2.3

Hide thumbs Also See for OmniAccess 700:

Table of Contents

Source NAT (SNAT) is mainly used for changing the source address of packets. A

good example would be that of a network behind a firewall, which interacts with

the external world. For the hosts behind the firewall to interact with the external

world, the local network's IP addresses have to be substituted with that of the

With this target, the firewall will automatically SNAT and De-SNAT the packets,

hence making it possible to make connections from the LAN to the Internet.

Refer the following section to configure SNAT on your system:

"SNAT Configuration Steps"

"SNAT Configuration Flow"

"SNAT Configuration Commands"

"Sample Configurations of SNAT on OA-700"

CLI Configuration Guide

ONFIGURATION

Alcatel-Lucent

Except on the first page, right running head:

Heading1 or Heading1NewPage text (automatic)

Source NAT Configuration