Snat Configuration Steps - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

Left running head:
Chapter name (automatic)
Network Address Translation
SNAT C
ONFIGURATION
This section lists the steps to be followed while configuring SNAT.
Step 1: Configure the match-lists with the common classifiers pre-configured.
(Refer the "Common Classifiers"
Step 2: Enter the NAT Configuration Mode. See
Mode"
Step 3: Configure SNAT. See
Step 4: Configure SNAT optional parameters.
•
•
•
•
•
Attach configured SNAT to an Interface
Step 5: Enter into Interface Configuration Mode
Step 6: Administratively bring up the interface
618
Beta
S
TEPS
in this guide)
"To Configure SNAT"
Configure SNAT with host IP address. See
IP Address"
Configure address pool. See
Pool"
Configure port range. See
Configure Static SNAT. See
Reorder the rules in the match-list for the configured SNAT. See
Reorder the Rules in SNAT"
ALU(config)# interface <name>
Example:
ALU(config)# interface GigabitEthernet7/0
ALU(config-if GigabitEthernet7/0)#
ALU(config-if <interface-name>)# no shutdown
Example:
ALU(config-if GigabitEthernet7/0)# no shutdown
Alcatel-Lucent
"To Enter NAT Configuration
"To Configure SNAT with Host
"To Configure SNAT with an IP Address
"To Configure SNAT with Port Range"
"To Configure Static SNAT"
"To
CLI Configuration Guide
Beta