Irb Configuration; Irb Configuration Steps - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

IRB C
ONFIGURATION
The following section details the configuration steps and commands to configure
IRB on the OA-700.
IRB C
ONFIGURATION
Step 1: Configure the VLAN interface. This could also be for VLAN 1. See
Configure VLAN Interface"
Step 2: Attach the VLAN to one or more switchports (through the CLI commands
for access, trunk and hybrid ports).
(Refer chapter on switching
insight on the VLAN commands)
Step 3: Configure IP address, and attach policies such as Filter, IDS, etc., on the
VLAN interface (through known CLI commands for other services).
Note: - A given VLAN interface for IRB can be used only on the 8 ports of the same L2-GE
card.
- The IRB VLANs cannot be configured on the Service Engine ports.
CLI Configuration Guide
Beta
S
TEPS
"Layer 2 Switching Configuration"
Alcatel-Lucent
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
for a detailed

IRB Configuration

"To
201
Beta