Cac Configuration; Cac Configuration Steps - Alcatel-Lucent OmniAccess 700 Cli Configuration Manual

Left running head:
Chapter name (automatic)
Call Admission Controller
CAC C
ONFIGURATION
This section includes the following:
•

"CAC Configuration Steps"

•
"CAC Configuration Flow"
•
"CAC Configuration Commands"
•
"Show Commands in CAC"
•
"Clear Commands in CAC"
CAC C
ONFIGURATION
This section lists the steps for configuring CAC support required for voice traffic on
OA-700.
Step 1: Enter Configuration Mode
Step 2: Enter Admission Control Configuration Mode. See
Control Configuration Mode"
Step 3: Configure CAC object. See
Step 4: Configure parameters (bandwidth/call threshold or both) under a CAC
object. See
Note: The following configurations are pre-requisite for bandwidth based CAC:
- Match-list that matches voice traffic
- Class map with a match-list for RTP traffic.
- QoS policy map. Traffic class as priority class, with bandwidth configuration.
- Apply QoS policy on the egress interface on which CAC is to be applied.
For more details on configuring match-lists, refer to
and refer to
Step 5: Configure an interface. Enter Interface Configuration Mode.
868
Beta
S
TEPS
ALU# configure terminal
ALU(config)#
"To Configure Parameters Under a CAC Object"
"Quality of Service" chapter for QoS configuration in this guide.
ALU(config)# interface <name>
Example:
ALU(config)# interface GigabitEthernet7/0
ALU(config-if GigabitEthernet7/0)#
Alcatel-Lucent
"To Enter Admission
"To Create a CAC Object"
"Common Classifiers" chapter,
CLI Configuration Guide
Beta