Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual page 34

1
What's New
Command
:POWer:SIGNals:VMAXimum:ONOFf:ON (see
page
:POWer:SIGNals:VSTeady:ONOFf:OFF (see
page
:POWer:SIGNals:VSTeady:ONOFf:ON (see
page
:POWer:SIGNals:VSTeady:TRANsient (see
page
:WGEN:MODulation:AM:DEPTh (see
page
:WGEN:MODulation:AM:FREQuency (see
page
:WGEN:MODulation:FM:DEViation (see
page
:WGEN:MODulation:FM:FREQuency (see
page
:WGEN:MODulation:FSKey:FREQuency (see
page
:WGEN:MODulation:FSKey:RATE (see
page
:WGEN:MODulation:FUNCtion (see
:WGEN:MODulation:FUNCtion:RAMP:SYMMet
ry (see
:WGEN:MODulation:STATe (see
:WGEN:MODulation:TYPE (see
Changed
Commands
Command
:BLANk (see
34
577)
578)
579)
580)
1013)
1014)
1015)
1016)
1017)
1018)
page 1020)
page
page
page 198)
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
Description
Specifies the maximum expected input voltage
for turn on analysis.
Specifies the expected steady state output DC
voltage of the power supply for turn off
analysis.
Specifies the expected steady state output DC
voltage of the power supply for turn on
analysis.
Specifies the expected steady state output DC
voltage of the power supply for transient
response analysis.
Specifies the amount of amplitude modulation.
Specifies the frequency of the modulating
signal.
Specifies the frequency deviation from the
original carrier signal frequency.
Specifies the frequency of the modulating
signal.
Specifies the "hop frequency".
Specifies the rate at which the output
frequency "shifts".
page 1019) Specifies the shape of the modulating signal.
Specifies the amount of time per cycle that the
ramp waveform is rising.
1022) Enables or disables modulated waveform
generator output.
1023) Selects the modulation type: Amplitude
Modulation (AM), Frequency Modulation (FM),
or Frequency-Shift Keying Modulation (FSK).
Differences
You can now use the WMEMory<r> source parameter to turn
off the display of a reference waveform location.