Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual page 5

•
•
•
•
•
•
•
•
•
•
•
•
•
•
The command descriptions in this reference show upper and lowercase
characters. For example, :AUToscale indicates that the entire command
name is :AUTOSCALE. The short form, :AUT, is also accepted by the
oscilloscope.
Then, there are chapters that describe programming topics and conceptual
information in more detail:
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
Chapter 23, ":POD Commands," starting on page 523, describes
commands that control all oscilloscope functions associated with groups
of digital channels.
Chapter 24, ":POWer Commands," starting on page 529, describes
commands that control the DSOX3PWR power measurement application.
Chapter 25, ":RECall Commands," starting on page 597, describes
commands that recall previously saved oscilloscope setups, reference
waveforms, or masks.
Chapter 26, ":SAVE Commands," starting on page 605, describes
commands that save oscilloscope setups, screen images, and data.
Chapter 27, ":SBUS<n> Commands," starting on page 629, describes
commands that control oscilloscope functions associated with the serial
decode bus and serial triggering.
Chapter 28, ":SEARch Commands," starting on page 777, describes
commands that control oscilloscope functions associated with searching
for waveform events.
Chapter 29, ":SYSTem Commands," starting on page 851, describes
commands that control basic system functions of the oscilloscope.
Chapter 30, ":TIMebase Commands," starting on page 865, describes
commands that control all horizontal sweep functions.
Chapter 31, ":TRIGger Commands," starting on page 877, describes
commands that control the trigger modes and parameters for each
trigger type.
Chapter 32, ":WAVeform Commands," starting on page 959, describes
commands that provide access to waveform data.
Chapter 33, ":WGEN Commands," starting on page 995, describes
commands that control waveform generator (Option WGN) functions and
parameters.
Chapter 34, ":WMEMory<r> Commands," starting on page 1033,
describes commands that control reference waveforms.
Chapter 35, "Obsolete and Discontinued Commands," starting on page
1043, describes obsolete commands which still work but have been
replaced by newer commands and discontinued commands which are no
longer supported.
Chapter 36, "Error Messages," starting on page 1097, lists the
instrument error messages that can occur while programming the
oscilloscope.
5