Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual page 42

1
What's New
Command
:TRIGger:DELay:ARM:SLOPe (see
:TRIGger:DELay:ARM:SOURce (see
:TRIGger:DELay:TDELay:TIME (see
:TRIGger:DELay:TRIGger:COUNt (see
:TRIGger:DELay:TRIGger:SLOPe (see
:TRIGger:DELay:TRIGger:SOURce (see
page
:TRIGger:FORCe (see
:TRIGger:OR (see
Changed
Commands
Command
:DEMO:FUNCtion (see
:TRIGger:MODE (see
:WGEN:FUNCtion (see
42
895)
page 880)
page 917)
page 282)
page 886)
page 1007)
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
Description
page 890) Specifies the arming edge slope for the Edge
Then Edge trigger.
page 891) Specifies the arming edge source for the Edge
Then Edge trigger.
page 892) Specifies the delay time for the Edge Then Edge
trigger.
page 893) Specifies the trigger edge count for the Edge
Then Edge trigger.
page 894) Specifies the trigger edge slope for the Edge
Then Edge trigger.
Specifies the trigger edge source for the Edge
Then Edge trigger.
Now documented, this command is equivalent
to the front panel [Force Trigger] key which
causes an acquisition to be captured even
though the trigger condition has not been met.
Specifies edges for the OR'ed edge trigger.
Differences
The ETE (Edge then Edge) function has been
added.
The OR and DELay modes are added for the
OR'ed edge trigger and the Edge Then Edge
trigger.
The SINC, EXPRise, EXPFall, CARDiac, and
GAUSsian waveform types can now be
selected.