Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual page 48

1
What's New
Command
:WAVeform:SOURce (see
page
:VIEW (see
Obsolete
Commands
Obsolete Command
Discontinued
Commands
Command
:ACQuire:RSIGnal
:CALibrate:SWITch?
:DISPlay:SOURce
:EXTernal:IMPedance
:EXTernal:PROBe:ID
:EXTernal:PROBe:STYPe
:EXTernal:PROTection
:HARDcopy:DEVice,
:HARDcopy:FORMat
:MERGe
:RECall:IMAGe[:STARt]
:SYSTem:PRECision
:TIMebase:REFClock
48
981)
page 225)
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
Differences From InfiniiVision 7000B Series Oscilloscopes
Can select reference waveforms as the source.
PMEMory (pixel memory) locations are not present.
Current Command Equivalent
Description
The 3000 X-Series oscilloscope does not have a 10 MHz REF
BNC connector.
Replaced by :CALibrate:PROTected? (see
oscilloscope has a protection button instead of a switch.
PMEMory (pixel memory) locations are not present.
External TRIG IN connector is now fixed at 1 MOhm.
Not supported on external TRIG IN connector.
Not supported on external TRIG IN connector.
Not supported on external TRIG IN connector.
Use the :SAVE:IMAGe:FORMat, :SAVE:WAVeform:FORMat, and
:HARDcopy:APRinter commands instead.
Waveform traces have been replaced by reference waveforms.
Waveform traces have been replaced by reference waveforms.
The 3000 X-Series oscilloscopes' measurement record is 62,500
points, and there is no need for a special precision mode.
The 3000 X-Series oscilloscope does not have a 10 MHz REF
BNC connector.
Behavior Differences
page 256). The