Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual page 35

Command
:STATus (see
:VIEW (see
Discontinued
Commands
Discontinued Command
:POWer:SIGNals:CYCLes
:POWer:SIGNals:DURation
:POWer:SIGNals:VMAXimum
:POWer:SIGNals:VSTeady
:POWer:SLEW:VALue
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
Differences
page 222) You can now use the WMEMory<r> source parameter to view
the display status of a reference waveform location.
page 225) You can now use the WMEMory<r> source parameter to turn on
the display of a reference waveform location.
Current Command Equivalent
:POWer:SIGNals:CYCLes:HAR
Monics (see
:POWer:SIGNals:CYCLes:QUA
Lity (see
:POWer:SIGNals:DURation:EF
Ficiency (see
:POWer:SIGNals:DURation:M
ODulation (see
:POWer:SIGNals:DURation:ON
OFf:OFF (see
:POWer:SIGNals:DURation:ON
OFf:ON (see
:POWer:SIGNals:DURation:RIP
Ple (see
:POWer:SIGNals:DURation:TR
ANsient (see
:POWer:SIGNals:VMAXimum:I
NRush (see
:POWer:SIGNals:VMAXimum:
ONOFf:OFF (see
:POWer:SIGNals:VMAXimum:
ONOFf:ON (see
:POWer:SIGNals:VSTeady:ON
OFf:OFF (see
:POWer:SIGNals:VSTeady:ON
OFf:ON (see
:POWer:SIGNals:VSTeady:TRA
Nsient (see
none
Comments
This command was separated
page 565) into several other commands
for specific types of power
analysis.
page 566)
This command was separated
page 567) into several other commands
for specific types of power
analysis.
page 568)
page 569)
page 570)
page 571)
page 572)
This command was separated
page 575) into several other commands
for specific types of power
analysis.
page 576)
page 577)
This command was separated
page 578) into several other commands
for specific types of power
analysis.
page 579)
page 580)
Slew rate values are now
displayed using max and min
measurements of a
differentiate math function
signal.
1
What's New
35