Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual page 39

Command
:SEARch:SERial:FLEXray Commands (see
page
:SEARch:SERial:M1553 Commands (see
page
:TRIGger:TV:UDTV:ENUMber (see
:TRIGger:TV:UDTV:HSYNc (see
:TRIGger:TV:UDTV:HTIMe (see
:TRIGger:TV:UDTV:PGTHan (see
:WGEN:ARBitrary:BYTeorder (see
:WGEN:ARBitrary:DATA (see
:WGEN:ARBitrary:DATA:ATTRibute:POINts?
(see
:WGEN:ARBitrary:DATA:CLEar (see
:WGEN:ARBitrary:DATA:DAC (see
:WGEN:ARBitrary:INTerpolate (see
:WGEN:ARBitrary:STORe (see
:WGEN:MODulation:NOISe (see
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
814)
839)
page
page
page
page 1001)
page
Description
Commands for finding FlexRay events in the
captured data.
Commands for finding MIL-STD 1553 events in
the captured data.
page 949) Specifies the Nth edge to trigger on with the
Generic video trigger. Available with the
DSOX3VID extended Video triggering license.
950) Enables or disables the horizontal sync control
in the Generic video trigger. Available with the
DSOX3VID extended Video triggering license.
951) When the Generic video trigger's horizontal
sync control is enabled, this command
specifies the sync time. Available with the
DSOX3VID extended Video triggering license.
page 952) Specifies the "greater than the sync pulse
width" time in the Generic video trigger.
Available with the DSOX3VID extended Video
triggering license.
page 999) Selects the byte order for arbitrary waveform
binary transfers.
1000) Downloads an arbitrary waveform in
floating-point values format.
Returns the number of points used by the
current arbitrary waveform.
page 1002) Clears the arbitrary waveform memory and
restores the default waveform.
page 1003) Downloads an arbitrary waveform in integer
(DAC) values.
page 1004) Enable or disables interpolated values between
points in the arbitrary waveform.
1005) Captures a waveform and stores it into
arbitrary waveform memory.
page 1021) Adds noise to the waveform generator's output
signal.
1
What's New
39