Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual page 46

1
What's New
Command
:MEASure:PPULses (see
page
:MEASure:WINDow (see
page
:MTESt:ALL (see
:RECall:WMEMory<r>[:STARt]
(see
:SAVE:WMEMory:SOURce
(see
:SAVE:WMEMory[:STARt]
(see
:SBUS<n>:CAN Commands
(see
:SBUS<n>:I2S Commands
(see
:SBUS<n>:IIC Commands (see
page
:SBUS<n>:LIN Commands
(see
:SBUS<n>:SPI Commands
(see
:SBUS<n>:UART Commands
(see
:SEARch:EDGE Commands
(see
:SEARch:GLITch Commands
(see
:SEARch:RUNT Commands
(see
:SEARch:TRANsition
Commands (see
:TRIGger:LEVel:HIGH (see
page
:TRIGger:LEVel:LOW (see
page
:TRIGger:PATTern Commands
(see
46
435)
466)
page 494)
page 604)
page 626)
page 627)
page 652)
page 688)
707)
page 717)
page 652)
page 754)
page 782)
page 785)
page 792)
page 782)
884)
885)
page 918)
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
Description
Counts the number of positive pulses.
When the zoomed time base in on, specifies whether the
measurement window is the zoomed time base or the main time
base.
Specifies whether all channels are included in the mask test.
Recalls reference waveforms.
Selects the source for saving a reference waveform.
Saves reference waveforms.
This subsystem contains commands/functions that are in the
7000B Series oscilloscope's :TRIGger:CAN subsystem.
This subsystem contains commands/functions that are in the
7000B Series oscilloscope's :TRIGger:I2S subsystem.
This subsystem contains commands/functions that are in the
7000B Series oscilloscope's :TRIGger:IIC subsystem.
This subsystem contains commands/functions that are in the
7000B Series oscilloscope's :TRIGger:LIN subsystem.
This subsystem contains commands/functions that are in the
7000B Series oscilloscope's :TRIGger:SPI subsystem.
This subsystem contains commands/functions that are in the
7000B Series oscilloscope's :TRIGger:UART subsystem.
Commands for searching edge events.
Commands for searching glitch events.
Commands for searching runt events.
Commands for searching edge transition events.
Sets runt and transition (rise/fall time) trigger high level.
Sets runt and transition (rise/fall time) trigger low level.
This subsystem contains commands/functions that are in the
7000B Series oscilloscope's :TRIGger:DURation subsystem.