Area Range (Router Ospf) - Dell Networking 7048 Reference Manual

Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures the translator stability interval of the area
20 NSSA.
console(config-router)#area 20 nssa translator-stab-intv 2000

area range (Router OSPF)

Use the area range command in Router OSPF Configuration mode to
configure a summary prefix that an area border router advertises for a specific
area. There are two types of area ranges. An area range can be configured to
summarize intra-area routes. An ABR advertises the range rather than the
specific intra-area route as a type 3 summary LSA. Also, an area range can be
configured at the edge of an NSSA to summarize external routes reachable
within the NSSA. The range is advertised as a type 5 external LSA.
Use the no form of the command to delete an area range or revert an option
to its default.
Syntax
area-id
area range
[advertise | not-advertise][cost
area-id
no area
Parameter Description
Parameter
area-id
prefix netmask
1156
OSPF Commands
prefix netmask
prefix netmask
range
Description
Identifies the OSPF NSSA to configure. (Range: IP address or
decimal from 0–4294967295)
The summary prefix to be advertised when the ABR computes a
route to one or more networks within this prefix in this area.
{summarylink | nssaexternallink}
cost
]
{summarylink | nssaexternallink}