Set Cep Port - Enterasys Matrix 2G4072-52 Configuration Manual

Security Configuration Command Set
Configuring Convergence End Points (CEP) Phone Detection
14.3.8.6

set cep port

Use this command to enable or disable a CEP detection type on one or more ports.
set cep port port-string {cisco | h323 | siemens | sip} {enable | disable}
Syntax Description
port-string
cisco
h323
siemens
sip
enable | disable
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable Cisco phone detection on port fe. 3. 1
Matrix>set cep port fe.3.1 cisco enable
14-108 Matrix DFE-Platinum and Diamond Series Configuration Guide
Specifies the port(s) to enable or disable. For a detailed
description of possible port-string values, refer to
Section 4.1.1.
Set the Cisco detection status on the specified ports.
Set the H323 detection status on the specified ports.
Set the Siemens detection status on the specified ports.
Set the SIP detection status on the specified ports.
Enables or disables CEP detection as specified.
: