Clear Cep - Enterasys Matrix 2G4072-52 Configuration Manual

Security Configuration Command Set
Configuring Convergence End Points (CEP) Phone Detection

14.3.8.14 clear cep

Use this command to clear convergence end points parameters.
clear cep {all | policy | detection [detection-id] | users [port-string] | port
[port-string {all | cisco | h323 | siemens |sip} ] }
Syntax Description
all
policy
detection
[detection-id]
users [port-string] Clear discovered Convergence Endpoints. Optionally,
port [port-string
{all | cisco | h323 |
siemens | sip }]
Command Defaults
If no detection-id is specified, all CEP detection groups are returned to the default
configuration.
If no port-string is specified with the users parameter, all discovered Convergence
Endpoints are cleared.
If no port-string is specified with the port parameter, all ports are cleared.
Command Type
Switch command.
Command Mode
Read-Write.
14-116 Matrix DFE-Platinum and Diamond Series Configuration Guide
Restores factory defaults to all CEP configuration
information.
Restore factory defaults to CEP policy configuration.
Restore factory defaults to CEP detection group
configuration. Optionally, specify a particular CEP
configuration group to clear with detection-id. Valid values
are 1 - 2147483647.
specify one or more port(s) on which to clear discovered
CEPs. For a detailed description of possible port-string
values, refer to Section
Resets the CEP enabled state to the default of disabled.
Optionally, specify one or more port(s) to disable and
specify all detection types or individual detection types to
disable. For a detailed description of possible port-string
values, refer to Section
4.1.1.
4.1.1.