Delta ASDA-B2 Series User Manual page 93

Chapter 5 Trial Operation and Tuning
Inspection before
running the servo
drive
(has already applied
to the power)
5-2

The encoder cable should avoid excessive stress. When the
motor is running, make sure the cable is not frayed or over
extended.

Please contact with Delta if there is any vibration of the servo
motor or unusual noise during the operation.

Make sure the setting of the parameters is correct. Different
machinery has different characteristic, please adjust the
parameter according to the characteristic of each machinery.

Please reset the parameter when the servo drive is in SERVO
OFF status, or it may cause malfunction.

When the relay is operating, make sure it can work properly.

Check if the power indicator and LED display works normally.

PWM is used to control 7.5 kW. Thus, when the temperature is
lower than 40℃, the fan does not work.
ASDA-B2
Revision May, 2018