Delta ASDA-B2 Series User Manual page 344

Appendix B Maintenance and
Basic Inspection
Item
General
inspection
Inspection before
operation
(has not applied
to the power yet)
Revision May, 2018
Periodically check if the screws of the servo drive, the connection
between the motor shaft and the mechanical system as well as the
connection of terminal block and mechanical system are securely
tightened.
The gap of the control chamber and the installation of the cooling
fan should free from oil, water or metallic particles. Also, the servo
drive shall free from the cutting power of the power drill.
If the control chamber is installed in the site which contains harmful
gas or full of dust, please be ensured the servo drive is free from the
harmful gas and dust.
When making encoder cable or wire rods, please be ensured the
wiring is correct. Otherwise, the motor may have sudden unintended
acceleration or be burned.
To avoid the electric shock, the ground terminal of the servo drive
should firmly connect to the ground terminal of the control chamber.
If the wiring is needed, wait at least 10 minutes after disconnecting
the drive from the main supply power, or discharge electricity by
discharge device.
The splicing parts of the wiring terminal should be isolated.
Make sure the wiring is correct so as to avoid the damage or any
abnormity.
Check if the electric conductivity objects including sheetmetal
(such as screws) or inflammable objects are not inside the servo
drive.
Check if the control switch is in OFF status.
Do not place the servo drive of external regenerative resistor on
inflammable objects.
To avoid the electromagnetic brake losing efficacy, please check
if stop function and circuit break function can work normally.
Inspection
Content
B-1