Delta ASDA-B2 Series User Manual page 71

Chapter 3 Wiring
The DI wiring inputs signal via the relay or open-collector transistor.
Conditions of DI On / Off:
ON: 15V - 24V; the input current is higher than 3 mA.
OFF: below 5V; the input current must not be higher than 0.5 mA.
NPN transistor, common emitter (E) mode (SINK mode)
C9: Wiring of DI signal
the internal power.
PNP transistor, common emitter (E) mode (SOURCE mode)
C11: Wiring of DI signal. The servo drive applies
to the internal power.

Caution: Do not apply to dual power or it may damage the servo drive.
3-32
.
The servo drive applies to C10: Wiring of DI signal. The servo drive
applies to the external power.
C12: Wiring of DI signal. The servo drive applies
to the external power.
ASDA-B2
Revision May, 2018