Delta ASDA-B2 Series User Manual page 303

Chapter 9 Troubleshooting
AL019
Serial communication error
AL020
Serial communication time out
AL022
Main circuit power leak phase
AL023
Early warning for overload
AL024
Encoder initial magnetic field error
AL025
The internal of the encoder is in error
AL026
The encoder is in error
AL027
The internal of the encoder is in error
AL028
The internal of the encoder is in error
AL029
The internal of the encoder is in error
AL030
Motor crash error
Incorrect wiring of the motor power
AL031
line U, V, W, GND
Encoder temperature exceeds the
AL035
protective range
AL048
Excessive encoder output error
AL067
Encoder temperature warning
AL083
Servo drive outputs excessive current Turn DI.ARST on to clear the alarm
AL085
Regeneration error
AL099
DSP firmware upgrade
AL555
DSP processing error
AL880
DSP processing error
9-16
Turn DI.ARST on to clear the alarm
Turn DI.ARST on to clear the alarm
Turn DI.ARST on to clear the alarm
Turn DI.ARST on to clear the alarm
The alarm can be cleared after
re-power on.
The alarm can be cleared after
re-power on.
The alarm can be cleared after
re-power on.
The alarm can be cleared after
re-power on.
The alarm can be cleared after
re-power on.
The alarm can be cleared after
re-power on.
Turn DI.ARST on to clear the alarm
The alarm can be cleared after
re-power on.
The alarm can be cleared after
re-power on.
Turn DI.ARST on to clear the alarm
The alarm will be cleared when the
temperature back to normal.
Turn DI.ARST on to clear the alarm
Firstly set P2-08 to 30. Then set it to
28. And the alarm will be cleared
after re-power on.
N/A
N/A
ASDA-B2
Revision May, 2018