Delta ASDA-B2 Series User Manual page 2

Thank you for purchasing ASDA-B2. This user manual provides the related information of
ECMA series servo motors. This manual includes:
Installation and inspection of servo drive and servo motor
The configuration of servo drive
Procedures of trial run
Control functions and adjustment methods of servo drives
Parameter
Communication protocol
Inspection and maintenance
Troubleshooting
Application examples
This manual addresses personnel with the following qualifications:
Servo system designers
Installation or wiring personnel
Trial and tuning personnel
Maintenance and inspection personnel
Before using the product, please read through this manual carefully in order to ensure the
correct use of the product. In addition, please place this manual safely for quick reference
whenever is needed. Please follow the rules below if you have not finished reading this
manual yet.
No water, corrosive gas and inflammable gas are allowed in installation
environment.
Three-phase power is prohibited to connect to U, V and W connector when
wiring. It is possible to damage the servo drive.
Ensure that the motor and drive are correctly connected to a ground.
The grounding method must comply with the electrical standard of the
country (Please refer to NFPA 70: National Electrical Code, 2005 Ed.).
Do not disconnect the servo drive, motor or change the wiring when
connecting to the power.
Be ensured that the emergency stop can be activated any time before
connecting to the power and operation.
Revision May, 2018
Preface
i