07/11/02 09:14:26 61TA0000_110_0293
DTC P1009:
NOTE:
• Before you troubleshoot, record all freeze data and
any on-board snapshot, and review the general
troubleshooting information (see page 11-3).
• If DTC P0341 is stored at the same time as DTC P1009,
troubleshoot DTC P1009 first, then recheck for DTC
P0341.
1. Turn the ignition switch to ON (II).
2. Clear the DTC with the HDS.
3. Start the engine.
4. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P1009 indicated?
YES
NO
−
time.
5. Turn the ignition switch to LOCK (0).
6. Remove the auto-tensioner (see page 4-33).
7. Remove the VTC strainer (A), and check it for
clogging.
*01
Is the strainer OK ?
YES
−
NO
filter and the engine oil, then go to step 10.
VTC Advance Malfunction
−
Go to step 5.
Intermittent failure, the system is OK at this
A
−
Go to step 8.
Clean the VTC strainer, replace the engine oil
8. Test the VTC oil control solenoid valve (see page
11-325).
Is the valve OK ?
YES
−
Go to step 9.
NO
−
Replace the VTC oil control solenoid valve
(see page 11-325), then go to step 10.
9. Inspect the VTC actuator (see page 6-8).
Is the actuator OK ?
−
YES
Check the VTC system oil passages, then go
to step 10.
NO
−
Replace the VTC actuator (see page 6-31),
then go to step 10.
10. Turn the ignition switch to ON (II).
11. Reset the ECM/PCM with the HDS.
12. Clear the CKP pattern with the HDS.
13. Do the ECM/PCM idle learn procedure (see page
11-343).
14. Do the CKP pattern learn procedure (see page 11-5).
15. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P1009 indicated?
YES
−
Check the oil passages at the VTC system,
then go to step 1.
−
NO
Troubleshooting is complete. If any other
Temporary DTCs or DTCs are indicated, go to the
indicated DTC's troubleshooting.
TA08AEAK72100091009FAAT00
11-293