Honda Accord 2008 Manual page 617

07/11/02 09:14:27 61TA0000_110_0298
VTEC/VTC
DTC Troubleshooting (cont'd)
7. At rocker arm oil pressure switch A side, check for
continuity between its 2P connector terminals.
＊０１
ROCKER ARM OIL PRESSURE SWITCH A 2P CONNECTOR
Is there continuity?
YES
−
NO
(see page 11-330), then go to step 29.
11-298
VTPSWA
GND
Terminal side of male terminals
− Go to step 8.
Replace rocker arm oil pressure switch A
8. Turn the ignition switch to ON (II).
9. Measure voltage between rocker arm oil pressure
switch A 2P connector terminal No. 1 and body
ground.
ROCKER ARM OIL PRESSURE SWITCH A 2P CONNECTOR
Wire side of female terminals
Is there battery voltage?
YES − Repair open in the wire between rocker arm
oil pressure switch A and G101 (see page 22-20),
then go to step 28.
−
NO Go to step 10.
10. Turn the ignition switch to LOCK (0).
11. Jump the SCS line with the HDS.
12. Disconnect PCM connector C (49P).
VTPSWA (BLU/BLK)
＊０２