Honda Accord 2008 Manual page 620

07/11/02 09:15:18 61TA0000_110_0301
28. Turn the ignition switch to LOCK (0).
29. Reconnect all connectors.
30. Turn the ignition switch to ON (II).
31. Reset the PCM with the HDS.
32. Do the idle learn procedure (see page 11-343).
33. Select the VTEC TEST in the INSPECTION MENU,
and do the VTEC TEST with the HDS.
Are V T ECIN-0 and V T ECEX -0 indicated?
−
YES Go to step 34.
NO − Check for poor connections or loose terminals
at rocker arm oil pressure switch A, rocker arm oil
control solenoid A, and the PCM, then go to step 1.
34. Check for Temporary DTCs or DTCs with the HDS.
Are any T emporary DT Cs or DT Cs indicated?
YES − If any other Temporary DTCs or DTCs are
indicated, go to the indicated DTC's
troubleshooting.
NO − Troubleshooting is complete.
35. Reconnect all connectors.
36. Update the PCM if it does not have the latest
software (see page 11-231), or substitute a known-
good PCM (see page 11-7).
37. Select the VTEC TEST in the INSPECTION MENU,
and do the VTEC TEST with the HDS.
Are V T ECIN-0 and V T ECEX -0 indicated?
YES − Go to step 38.
NO − If the PCM was updated, substitute a known-
good PCM (see page 11-7), then recheck. If the PCM
was substituted, go to step 1.
38. Check for DTCs or DTCs with the HDS.
Are any T emporary DT Cs or DT Cs indicated?
−
YES If any other Temporary DTCs or DTCs are
indicated, go to the indicated DTC's
troubleshooting.
NO − If the PCM was updated, troubleshooting is
complete. If the PCM was substituted, replace the
original PCM (see page 11-232).
11-301