Honda Accord 2008 Manual page 588

07/11/02 09:13:32 61TA0000_110_0269
12. Check for continuity between ECM/PCM connector
terminal A19 and body ground.
＊０４
Is there continuity?
YES
−
NO
PCM (A19) and APP sensor B, then go to step 24.
13. Reconnect ECM/PCM connector A (49P).
14. Connect APP sensor 6P connector terminals No. 4
and No. 6 with a jumper wire.
＊０５
ECM/PCM CONNECTOR A (49P)
APSB (ORN)
Terminal side of female terminals
− Go to step 13.
Repair open in the wire between the ECM/
APP SENSOR 6P CONNECTOR
APSB (ORN) VCC5 (BRN)
JUMPER WIRE
Wire side of female terminals
15. Turn the ignition switch to ON (II).
16. Check APP SENSOR B in the DATA LIST with the
HDS.
Is there about 0.2 V or less?
YES − Go to step 29.
−
NO Go to step 22.
17. Turn the ignition switch to LOCK (0).
18. Jump the SCS line with the HDS.
19. Disconnect ECM/PCM connector A (49P).
20. Connect APP sensor 6P connector terminal No. 6 to
body ground with a jumper wire.
APP SENSOR 6P CONNECTOR
Wire side of female terminals
VCC5 (BRN)
JUMPER WIRE
(cont'd)
11-269
＊０６