Wgen:period - Agilent Technologies InfiniiVision 2000 X-Series Programmer's Manual

31
:WGEN Commands

:WGEN:PERiod

Command Syntax
:WGEN:PERiod <period>
<period> ::= period in seconds in NR3 format
For all waveforms except Noise and DC, the :WGEN:PERiod command
specifies the period of the waveform.
You can also specify the period indirectly using the :WGEN:FREQuency
command.
Query Syntax
:WGEN:PERiod?
The :WGEN:PERiod? query returns the currently set waveform generator
period.
Return Format
<period><NL>
<period> ::= period in seconds in NR3 format
See Also •
•
•
686
(see page 790)
"Introduction to :WGEN Commands"
":WGEN:FUNCtion" on page 667
":WGEN:FREQuency"
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
on page 665
on page 666