Dodge RAM TRUCK 1500 1995 Service Manual page 1350

mm
114111 MANUAL TRANSMISSION 21 - 87
(18) Remove first gear synchro stop ring and clutch
ring (Fig. 63).
FIRST GEAR
CLUTCH RING
FIRST GEAR
STOP RING
J9221-131
Fig. 63 First Gear Stop And dutch Ring Removal
(19) Remove first speed clutch gear front snap ring
from mainshaft hub (Fig. 64).
FIRST
SPEED
CLUTCH
GEAR
CLUTCH
GEAR
SNAP
RING
(FRONT)
J9221-132
Fig. 64 First Speed Clutch Gear Front Snap Ring
Removal
(20) Remove first speed clutch gear (Fig. 65).
(21) Remove first speed clutch gear rear snap ring
from mainshaft hub (Fig. 65). It is not really neces­
sary to remove this snap ring unless it, or the main-
shaft is to be replaced.
CLUTCH GEAR
: ^ < S ^ ^ S N A P RING (REAR)
FIRST
SPEED
CLUTCH
GEAR
J922M33
Fig. 65 First Speed Clutch Gear Removal
(22) Remove mainshaft rear bearing as follows:
(a) Assemble Puller Flange 6444-1 and Puller
Rods 6444-3 (Fig. 66).
(b) Position first Puller Jaw 6445 on bearing
cone (Fig. 66).
(c) Seat Puller Flange 6444-1 In notch of first
puller jaw (Fig. 66).
(d) Install second Puller Jaw 6445 on bearing
cone and on puller flange (Fig. 66).
(e) Slide Retaining Collar 6444-8 over puller
jaws to hold them in place (Fig. 67). Note that re­
taining collar has small lip on one end and only fits
one way over jaws.
(f) Install Puller 6444 on puller rods. Then se­
cure puller to rods with retaining nuts (Fig. 67).
(g) Place holding wrench on hex ^at top of puller
(Fig. 67). Then tighten puller bolt with adjustable
wrench to remove bearing from shaft (Fig. 67). If
bearing proves difficult to remove, tap end of puller
bolt with copper hammer after each turn of bolt.
This will help loosen bearing on shaft and ease re­
moval.
(23) Remove bearing puller tools.
(24) Remove reverse gear thrust washer (Fig. 68).