Dodge RAM TRUCK 1500 1995 Service Manual page 1488

B R - 46RH/47W" TMNSMISSION OVERHAUL 21 - 217
(16) Lift valve body upward. Push solenoid connec­
tor and manual lever shaft out of case. Then raise
valve body, guide park rod out of case and remove
valve body (Fig. 15). Do not use boost valve tube
to lift valve body. Set valve body aside for disas­
sembly, cleaning and inspection.
VALVE
BODY
ASSEMBLY
BOOST
VALVE
TUBE
PARK
ROD
CASE
CONNECTOR
MANUAL
LEVER
SHAFT
J 9 3 2 M 3 6
Fig. 15 Valve Body Removal
(17) Remove accumulator outer spring, piston and
inner spring (Fig. 16), Note position of piston and
springs for assembly reference. Remove and discard
piston seals if worn or cut.
ACCUMULATOR
PISTON
OUTER
SPRING
J9121-208
Fig. 16 Accumulator Component Removal
(18) Remove front band lever pin access plug (Fig.
17). Use square end of 1/4 in. drive extension to re­
move plug as shown.
(19) Remove oil pump and reaction shaft support
assembly as follows:
(a) Tighten front band adjusting screw until
band is tight around front clutch retainer (Fig. 18).
This will prevent retainer from coming out with
pump and possibly damaging clutch or pump com­
ponents.
J912M7
Fig. 17 Front Band Lsver Pin Access Plug Removal/
Installation
LOCKNUT
ADJUSTING
SCREW
5/16 OPEN
END WRENCH
Fig. 18 Tightening Front Band! so Hold Front Clutch
In Place
(b) Remove oil pump bolts.
(c) Thread Slide Hammer Tools C-3752 into
threaded holes in flange of oil pump housing (Fig. 19).
UMP
HOUSING
J9121-14
Fig. 19 installing Oil Pump Remover Tools