mm
l ¥ 3 i l i MANUAL TRANSMISSION
21 - 43
(12) Install and start housing attaching bolts by
hand (Fig. 132). Then tighten bolts to 30-35 N-m
(22-26 ft. lbs.) torque.
Fig. 132 installing Housing Attaching
Bolts
(13) Install shift shaft bushing lock bolt (Fig. 133).
Apply Mopar Gasket Maker, or Loctite 518 to bolt
threads, shank and underside of bolt head before in
stallation.
Fig. 133 Installing Shift Shaft Bushing Lock Bolt
CAUTION; If the Jock,bolt cannot be fully installed,
do not try to force it into place. Either the shift
shaft is not in Neutral, or the shaft bushing (or le
ver) is misaligned (Fig. 134).
L O C K
F R O N T
BOLT
HOUSING
J942M28
Fig. 134 Correct Alignment Of Lock Bolt And Shaft
Bushing
(14) Lubricate then install shift shaft
detent
plunger in housing bore (Fig. 135). Lubricate plunger
with petroleum jelly or gear lubricant. Be sure
plunger is fully seated in detent notch in shift
shaft.
Fig, 135 installing Shift Shaft Detent Plunger