Dodge RAM TRUCK 1500 1995 Service Manual page 1665

23 - 41 INTERIOR COiPONElTS
B R
EMERGENCY JACK AID TOOL ST—CLUB CAB
The axle jack is stored behind the passenger seat
in the right rearquarter trim panel and is held in
place with a rubber strap (Fig. 10). Remove the ac­
cess cover, pull down firmly on the strap handle and
free the eyelet from the hook. Rotate the thumbwheel
counterclockwise until the jack is loose and remove
the jack.
The emergency jack tool kit is located in a tool
pouch under the rear seat (Fig. 11).
Fig. 10 Axle Jack—Club Cab
Fig. 11 Tool Kit—Club Cab
FLOOR SHIFT BOOT—1A1UAL
MEMOVAL
(1) Pull edge of floor shift boot upward to expose
fasteners (Fig. 12).
(2) Remove screws holding floor shift boot to floor.
(8) Remove gear shift knob.
(4) Separate gear shift boot from floor.
(5) Lift floor shift boot off shifter.
INSTALLATION
Reverse the preceding operation.
FLOOR SHIFT
Fig. 12 Floor Shift Boot—Manual
FLOOR SHIFT BOOT—4WD MANUAL
REMOVAL
(1) Pull edge of floor shift boot upward to expose
fasteners (Fig. 13).
FLOOR SHIFT
Fig. 13 Floor Shift Boot—4WD Manual
(2) Remove screws holding floor shift boot to floor.
(3) Remove gear shift knob.
(4) Separate gear shift boot from floor.
(5) Lift floor shift boot off shifter.
INSTALLATION
Reverse the preceding operation.
FLOOR SHIFT BOOT—4WD AUTOMATIC
REMOVAL
(1) Pull edge of floor shift boot upward to expose
fasteners (Fig. 14).
(2) Remove screws holding floor shift boot to floor.
(3) Remove gear shift knob.
(4) Separate gear shift boot from floor.
(5) Lift floor shift boot off shifter.