Dodge RAM TRUCK 1500 1995 Service Manual page 1547

21 - 266 42RH/46RH/47RH OVERDRIVE UNIT OVERHAUL — — — BR
SNAP
RING
FILTER
J9521-2C
Fig. 38 Governor Weight Retainer Washer And Snap
Ring Removal
GOVERNOR
BODY
BOLT (4)
GOVERNOR
DRIVE
COUNTERWEIGHT
J9521-19
Fig. 39 Governor Body Attaching Bolts And Spacer
Removal
(b) Carefully work a seal into each groove of
drive. Avoid overspreading seals during installation
to ensure tight fit.
(c) Verify that diagonally cut ring ends are prop­
erly interlocked (Fig. 43).
(2) Insert filter in governor drive. Filter goes in
hole to right of key slot as shown in Figure 40.
GOVERNOR
BODY
GOVERNOR
DRIVE
J9521-22
Fig. 40 Governor Body And Filter Position (On
Drive)
SPECIAL
TOOL
6823
INNER
WEIGHT
SNAP
RING
INTERMEDIATE
WEIGHT
SUITABLE
SIZE
SOCKET J9521-33
Fig. 41 Inner Weight Snap Ring Removal/Installation
(3) Align and position governor body on drive. Be
sure filter is seated in recess in governor body (Fig.
40).
(4) Install and tighten governor body bolts snug
but not to specified torque at this time.
(5) Assemble governor weight components (Fig.
44). Be very sure outer, intermediate and inner
weights are clean. Set weight assembly aside tem­
porarily. Assembly will not be installed until af­
ter governor drive is seated on output shaft.