Dodge RAM TRUCK 1500 1995 Service Manual page 1527

21 - 248 4SRH/47RH TRANSMISSION OVERHAUL
B R
(8) Install front servo piston rod guide as follows:
(a) Place Tool SP-5560 (or similar size tool) on guide
and position C-clamp on tool and case (Fig. 143).
(b) Slowly compress rod guide while simultaneously
easing seal ring into bore with suitable tool.
(9) Install rod guide snap ring (Fig. 143).
Fig. 143 Front Servo Rod Guide And Snap Ring
installation
OVERRUNNING CLUTCH, REAR BAND,
LOW-REVERSE DRUM, AND OVERDRIVE
PISTON RETAINER INSTALLATION
(1) Install new gasket at rear of transmission case.
Use petroleum jelly to hold gasket in place. Be sure
to align governor feed holes in gasket with feed
passages in case (Fig. 144). Install gasket before
overdrive piston retainer. Center hole in gasket
is smaller than retainer and cannot be installed
over retainer.
Fig. 144 Case Gasket Installation
(2) Install overdrive piston retainer. Be sure gover­
nor tube bores in retainer are aligned with governor
feed passages in gasket and case (Fig. 145).
(3) Install and tighten piston retainer bolts to 17
N-m (13 ft. lbs.) torque.
Fig. 145 Overdrive Piston Retainer Installation
(4) Install overrunning clutch components if not
yet installed. Refer to Overrunning Clutch Overhaul
in this section for procedures if necessary.
(5) Install 46RH rear band and low-reverse
drum as follows:
(a) Position band and link in case (Fig. 146). Be
sure notched side of link faces away from band.
Fig. 146 Rear Band And Link Installation (46RH)