Dodge RAM TRUCK 1500 1995 Service Manual page 1490

(24) Remove front and rear clutch assemblies as a
unit (Fig. 24). Set assemblies aside for disassembly
and inspection after removal.
Fig. 24 Front/Rear Clutch Assembly Removal
(25) Remove front band pivot pin and lever. Start
pin through lever and out of case bore with pin
punch. Then use pencil magnet to withdraw pin com­
pletely (Fig. 25).
Fig. 25 Front Band Lever And Pin Removal
(26) Remove intermediate shaft thrust washer. Tri­
angular shaped washer will either be on shaft pilot
hub or in rear clutch retainer (Fig. 26).
(27) Remove thrust plate from intermediate shaft
hub (Fig. 27).
(28) Remove intermediate shaft-planetary
geartrain assembly (Fig. 28). Set assembly aside for
disassembly and inspection later in procedure.
46RH/47RH TRANSMISSION OVERHAUL 21 - 209
Fig. 27 intermediate Shaft Thrust Plate Removal
ASSEMBLY
J9121-508
Fig. 28 intermediate Shaft/Planetary Geartrain
Removal