Dodge RAM TRUCK 1500 1995 Service Manual page 1660

B R
INTERIOR COMPONENTS 23 - 35
(5) Turn release handle to disengage seat from
stowed position and push seat cushion downward to
lock into place,
INTERIOR TRIM PANELS
CAUTION: Do not attempt to remove interior trim
panels/mouldings without first removing the neces­
sary adjacent panels.
To avoid damaging the panels, ensure that all the
screws and clips are removed before attempting to re­
move an interior trim panel/moulding. T r i m panels
a r e somewhat flexible but
can
be damaged if
bandied improperly.
DOOR SILL AND COWL COVER
REMOVAL
(1) Remove screw holding cowl trim to cowl.
(2) Remove screws holding door sill cover to floor
at door sill (Fig. 1).
Fig. 1 Door Sill and Cowl Cover
(3) Separate door sill and cowl trim from vehicle.
INSTALLATION
Reverse the preceding operation.
A-PILLAR GRAB HANDLE
REMOVAL
(1) Using a small flat blade screw driver, Pry trim
plugs from A-pillar grab handle.
(2) Remove screws holding grab handle to A-pillar
(Fig.
2).
(3) Separate A-pillar grab handle from vehicle.
Fig. 2 A-pillar Grab Handle (4X4)
A-PILLAR MOLDING
D a m a g e to trim, molding m a y occur during r e ­
moval, verify availability of replacement mold­
ing before removing.
REMOVAL
(1) Remove A-pillar grab handle, if equipped.
(2) Disengage clips holding A-pillar molding to
A-pillar (Fig. 3).
J9423-72
Fig. 3 A-pillar Molding
(3) Separate A-pillar molding from vehicle.
I N S T A L L A T I O N
Reverse the preceding operation.
INSTALLATION
Reverse the preceding operation.