Dodge RAM TRUCK 1500 1995 Service Manual page 1363

21 - S I if4111 MANUAL TRANSMISSION —
(a) Position sleeve on hub so tapered side of
sleeve faces rearward. Sleeve will fit either way
but will cause shift problems if Installed backwards
(Fig. 104).
(b) Rotate sleeve to align teeth on sleeve and
hub. Sleeve will slide easily into place on hub when
properly aligned.
(c) Install springs In gear hub (Fig. 104). Use pe­
troleum jelly to hold springs in place if desired.
(d) Compress first spring with flat blade screw­
driver and slide strut into position in hub slot.
Then work spring Into seat in strut with small
hooked tool, or screwdriver.
(e) Install second and third struts in same man­
ner as described in step (d).
(f) Work sleeve upward on hub until struts are
centered and seated in sleeve. Sleeve should be in
neutral position after seating struts.
HUB J922H89
Fig. 104 Reverse Gear Synchro Assembly
(12) Install reverse gear and synchro assembly on
mainshaft (Fig. 105). Rotate assembly until stop ring
lugs engage In hub slots and gear drops into fully
seated position.
(13) Install reverse gear thrust washer pin in
mainshaft (Fig. 106). Use needle nose pliers to Install
pin.
(14) Install reverse gear thrust washer (Fig. 107).
Be sure locating pin is seated in thrust washer notch.
BR
Fig. 107 Reverse Gear Thrust Washer installation