Dodge RAM TRUCK 1500 1995 Service Manual page 1222

14 - 1 4 0 COMPONENT REMOVAL/INSTALLATION—DIESEL ENGINE
(8) Connect the negative battery cables to both
batteries.
(9) Bleed the air from the high-pressure lines. Re­
fer to High- Pressure Line Bleeding in the Air Bleed
Procedure section at the front of this section of the
group.
FUEL SHUTDOWN SOLENOID
REMOVAL
The fuel shutdown solenoid is mounted to a bracket
located on the side of the fuel injection pump (Fig.
46).
FRONT OF ENGINE
AIR TEMPERATURE
SENSOR
SENSOR
ELECTRICAL
CONNECTOR
INTAKE
MANIFOLD
(UPPER HALF)
FUEL
SHUTDOWN
SOLENOID
SOLENOID
ELECTRICAL
CONNECTOR
J9414-93
Fig. 46 Fuel Shutdown Solenoid Location
(1) Disconnect the solenoid electrical connector
(Fig. 46).
(2) Disconnect clip at injection pump shutdown le­
ver (Fig. 47).
(3) Remove two solenoid mounting bolts.
(4) Remove solenoid from mounting bracket.
INSTALLATION . .
(1) Position solenoid to mounting bracket and in­
jection pump lever.
(2) Install clip at injection pump lever.
(3) Install and tighten two mounting bolts.
(4) Check and adjust the shaft length of the sole­
noid. Refer to the following procedure:
SOLENOID SHAFT ADJUSTMENT
After replacing the fuel shutdown solenoid, the so­
lenoid shaft length must be checked and (if neces­
sary) adjusted.
(1) Turn the ignition switch ON.
FUEL SHUTDOWN
SOLENOID
MOUNTING
BOLTS
SHUTDOWN
LEVER
LOCKNUTS CLIP
J9414-92
Fig. 47 Fuel Shutdown Solenoid Removal/
Installation
(2) Pull up (by hand) and hold on the solenoid le­
ver (Fig. 48). If the' solenoid is operating cor­
rectly, it should remain in the UP position with
the key in the ON position.
FUEL
SHUTDOWN
SOLENOID
HOLD SOLENOID
LEVER IN
"UP" POSITION
J9414-81
Fig. 48 Fuel Shutdown Solenoid Lever in Up
Position
(3) Take a measurement from the bottom of the so­
lenoid mounting bracket to the top of the injection
pump shutdown lever pin (Fig. 49).
(4) Dimension should be 66.9 mm (2.64 inches).