Dodge RAM TRUCK 1500 1995 Service Manual page 1296

N¥3SI§ M A N U A L TRANSMISSION 13
(9) Remove 3-4 fork. Rotate fork around synchro
sleeve fork until it clears shift arms and other forks
(Fig. 21).
3-4
FORK
1-2
AND
5TH-REVERSE
FORK ARMS
3-4
SYNCHRO
SLEEVE
J9421-44
Fig. 21 Removing 3-4 Shift Fork 16
(10) Support geartrain and rear housing on Assem­
bly Fixture Tool 6747 (with aid of helper) as follows:
(a) Adjust height of reverse idler pedestal rod to
18.42 cm (7-1/4 in.) Then position Adapters 6747-1
and 6747-2 on Assembly Fixture 6747.
(b) Slide fixture tool onto input shaft, counter­
shaft and idler gear (Fig. 22). The pedestal rod
on the fixture tool is used to support the re­
verse idler.
(c) Stand geartrain and rear housing upright on
fixture (Fig. 23). Have helper hold fixture tool in
place while housing and geartrain is being rotated
into upright position.
(d) Position 5 x 10 cm (2 x 4 in.) wood blocks un­
der legs of fixture tool. Blocks are needed to raise
fixture high enough for input shaft to clear work­
bench surface.
SPECIAL SPECIAL
TOOL TOOL
6747 6747-1
REVERSE
IDLER
PEDESTAL
INPUT SHAFT COUNTERSHAFT
SPECIAL
TOOL
6747
J9421-46
Fig. 23 Geartrain And Housing Mounted On Fixture
Tooi
(11) Remove bolts attaching reverse idler shaft and
shaft support segment to rear housing (Fig. 24).
REVERSE
IDLER
SHAFT
BOLT
LOCATIONS
SPECIAL
TOOL
6747
J9421-47
Fig. 24 Removing/lnstaliing Reverse Idler Shaft
Bolts
J9421-45
Fig. 22 Installing Assembly Fixture On Geartrain