Dodge RAM TRUCK 1500 1995 Service Manual page 1510

46RH/47RH TRANSMISSION OVERHAUL 21 - 229
(3) Install rear annulus gear on intermediate shaft
(Fig. 88).
OUTPUT
SHAFT
J9121-68
Fig, 88 installing Rear Annulus Gear On
intermediate Shaft
(4) Install thrust plate in annulus gear (Fig. 89).
Be sure plate is seated on shaft splines and against
gear.
THRUST
PLATE
J9121-69
Fig, 89 Rear Annulus Thrust Plate Installation
(5) Install rear planetary gear in rear annulus
gear (Fig. 90). Be sure planetary carrier is seated
against annulus gear.
(6) Install tabbed thrust washer on front face of
rear planetary gear (Fig. 91). Seat washer tabs in
matching slots in face of gear carrier. Use extra pe­
troleum jelly to hold washer in place if desired.
(7) Lubricate sun gear bushings with petroleum
jelly or transmission fluid.
(8) Install sun gear and driving shell on intermedi­
ate shaft (Fig. 92). Seat shell against rear planetary
gear. Verify that thrust washer on planetary gear
was not displaced during installation.
REAR
ANNULUS
GEAR
REAR
PLANETARY
GEAR
J9121-70
Fig, 90 Rear Planetary Gear Installation
REAR
PLANETARY
GEAR
TABBED
THRUST _
WASHER J9121-71
Fig. 91 Rear Planetary Thrust Washer installation
OUTPUT
SHAFT
DRIVING
SHELL
REAR
PLANETARY
GEAR
OUTPUT
SHAFT
SUN
GEAR
J9121-72
Fig. 92 Sun Gear And Driving Shell Installation