Dodge RAM TRUCK 1500 1995 Service Manual page 990

B R
Fig. 7 Generator Removal
Fig. 8 Heater Hoses
(26) Disconnect the fuel lines to the lift pump and
fuel return. Use tags to identify the lines.
(27) On Manual Transmission vehicles, remove the
shift lever (refer to Group 21, Transmissions).
(28) Raise and support the vehicle on a hoist.
(29) Drain the engine lubricating oil. Dispose of
the oil according to all applicable regulations.
(80) Remove the oil pan.
(81) Remove engine front mount thru-bolt nuts.
(32) Remove the transmission cooler line brackets
from oil pan.
(33) Disconnect exhaust pipe at manifold.
(34) Disconnect the starter wires. Remove starter
motor (refer to Group 8B, Battery/Starter/Generator
Service).
(35) Remove the dust shield and transmission
cover.
(86) Refer to Group 21, Transmissions for trans­
mission removal.
(37) Lower the vehicle.
(38) Put a cover or tape over all engine openings.
I J L (DIESEL) ENGINE 9 -149
Fig. 9 Air Inlet Tube and Exhaust Pipe Connection
(39) Lift the engine out of the vehicle.
(40) Install the engine on a suitable stand.
(41) Remove all accessories and brackets not previ­
ously removed for use with the replacement engine.
INSTALLATION
(1) Check the data plate to verify that the replace­
ment engine is the same model and rating as the en­
gine that was removed.
(2) Install all accessories and brackets that had
been removed from the previous engine.
(3) Use the lifting brackets to lift the engine off of
the stand.
(4) Position the engine in the chassis with the
thru-bolt installed.
(5) Remove the covers or tape covering the engine
openings.
(6) Raise and support the vehicle.
(7) Refer to Group 21, Transmissions for transmis­
sion installation.
(8) Install the dust shield and transmission cover.
(9) Install the prop shaft (refer to Group 16, Pro­
peller Shaft).
(10) Install the starter motor (refer to Group 8B,
Battery/Starter/Generator Service). Connect the
starter wires.
(11) Install the transmission cooler line brackets to
oil pan.
(12) Install and tighten engine front mount thru-
bolt nuts.
(13) Install the oil pan. Install the drain plug.
(14) Lower the vehicle.
(15) On Manual Transmission vehicles, install the
shift lever (refer to Group 21, Transmissions).