Dodge RAM TRUCK 1500 1995 Service Manual page 1444

m
(18) Remove hex head valve body attaching bolts
(Fig. 10).
J9321-135
Fig. 10 Valve Body Bolt Locations
(14) Lift valve body upward. Work solenoid connec­
tor out of case and remove valve body (Fig. 11). Set
valve body aside for disassembly, cleaning and in­
spection.
VALVE BOOST
BODY VALVE
ASSEMBLY TUBE
PARK CASE
ROD CONNECTOR J9321-136
Fig. 11 Valve Body Removal
(15) Remove accumulator piston and inner and
outer springs (Fig. 12).
(16) Remove front band reaction pin access plug (Fig.
13). Plug is accessible through converter housing. Use
1/4 inch drive extension to remove plug as shown.
mm TRANSMISSION OVERHAUL 21 -161
ACCUMULATOR OUTER
Fig. 12 Accumulator Piston And Springs
Fig. 13 Front Band Reaction Pin Access Plug Removal
(17) Loosen front band adjusting screw locknut 4-5
turns. Then tighten band adjusting screw until band
is tight around front clutch retainer. This prevents
front/rear clutches from coming out with pump and
possibly damaging clutch or pump components.
(18) Remove oil pump bolts.
(19) Thread bolts of Slide Hammer Tools C-3752
into threaded holes in pump body flange (Fig. 14).
(20) Bump slide hammer weights outward to re­
move pump and reaction shaft support assembly
from case (Fig. 14).
Fig. 14 Oil Pump/Reaction Shaft Support Removal
(21) Loosen front band adjusting screw until band
is completely loose.