Dodge RAM TRUCK 1500 1995 Service Manual page 1493

1 - 212 4liH/47RH TRANSMISSION OWERHAOl
B R
(g) Remove rear band and drum as assembly
(Fig. 38).
REACTION
PIN LUGS
J9421-445
Fig. 38 Low-Reverse Drum/Rear Band Removal
(47RH)
(h) Remove double wrap rear band from drum
(Fig. 39). Note that 47RH drum has shoulder to
maintain band position.
Fig. 39 Removing Double Wrap Rear Band From
Low-Reverse Drum (47RH)
(31) On all models, note that overrunning clutch
race will remain on splines of low-reverse drum after
removal (Fig. 40). The race is a permanent press
fit on the hub splines. Do not attempt to re­
move the race.
OVERRUNNING LOW-REVERSE
J9221-8
Fig. 40 Overrunning Clutch Race Position
(32) Remove overrunning clutch assembly (Fig.
41). Assembly can be removed without displacing
rollers and springs if care is exercised. Note position
of rollers and springs for assembly reference.
Fig. 41 Overrunning Clutch Removal
(33) Compress front servo rod guide with C-clamp
and Tool C-4470, or Valve Spring Compressor
C-3422-B (Fig. 42). Compress guide only enough to
permit snap ring removal (about 1/8 in.).
(34) Remove servo piston snap ring (Fig. 42). Un­
seat one end of ring. Then carefully work removal
tool around back of ring until free of ring groove. Ex-