Dodge RAM TRUCK 1500 1995 Service Manual page 1073

13 - 20 BUMPERS AND FRAME
B R
(4) Separate the switch cover from the housing
(Fig. 18).
(5) Detach the lamp holders from the switch cover.
Disconnect the wire harness connectors from the
switches (Fig. 18).
(6) Remove the nut, ring washer and lock washer
from each toggle switch (Fig. 18).
(7) Remove the toggle switches from the switch
cover (Fig. 18).
(8) Carefully pry the auxiliary headlamp switch
outward from the switch cover face. Remove it from
the switch cover (Fig. 18).
ASSEMBLY/IHSTALLATION
(1) Insert the auxiliary headlamp switch in the
switch cover opening. Carefully push inward until it
is completely seated against the cover face (Fig. 18).
(2) Position the toggle switches in the switch cover
openings. Install the lock washers, ring washers and
nuts (Fig. 18). Tighten the nuts with 5 N-m (45 in.
lbs.) torque.
(3) Insert the lamp holders in the switch cover
openings. Connect the wire harness connectors to the
switches (Fig. 18).
(4) Mate the switch cover with the module hous­
ing. Install the housing attaching screws (Fig. 18).
Tighten the screws until the screw heads are seated
against the housing.
(5) Position the control module on the instrument
panel with the slots aligned with the holes. Install
the retainers and screws (Fig. 17). Tighten the
screws until the module is tightly attached to the in­
strument panel.
INSTRUMENT
PANEL
WIRE
HARNESS
AUXILIARY
HEADLAMP
SWITCH
BLADE
RAISE/LOWER
SWITCH
RETAINER
SWITCH
COVER AND BEZEL
HOUSING
BLADE
ANGLE
SWITCH
J9123-424
Fig. 17 Snow Plow Control Module Removal/
Installation
BLADE SWITCH AUXILIARY
ANGLE COVER HEADLAMP
SWITCH I SWITCH
TRANS OIL
TEMP LAMP
(AUTO TRANS)
TO AUXILLARY
H/LAMP SWITCH
WIRE
HARNESS
NUT
RING
WASHER
LOCKWASHER
HOUSING
SCREW
'ILLUMINATION*
LAMP'
BLADE
RAISE/LOWER
SWITCH
TO SNO-PLOW CONTROL
SWITCH
(ANGLE)
TO SNO PLW CONTROL SWITCH
(RAISE/LOWER) J9l 23-425
Fig. 18 Snow Plow Control Module Disassembled